INSTALLATION (M/T models)

WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal after the following.
- Be sure the dowel pin is installed in the crankshaft.
- When installing the flywheel (3) to the crankshaft (2), be sure to correctly align crankshaft side dowel pin (1) to the flywheel side dowel pin hole (A) as shown.
  
  Fig 1: Aligning Crankshaft Side Dowel Pin To Flywheel Side Dowel Pin Hole
  Courtesy of SUZUKI OF AMERICA CORP.
  - Oil seal (4)
- There is a locator mark (B) on the clutch cover side of the flywheel (4). Refer to this for ease of installation.
  
  Fig 2: Identifying Locator Mark On Clutch Cover Side
  Courtesy of SUZUKI OF AMERICA CORP.
  - Crankshaft dowel pin (1)
  - Oil seal (2)
  - Crankshaft (3)
  - Flywheel (4)
  - Dowel pin hole (A)
  - Dowel pin locator mark (B)
- Tighten the flywheel bolts in a diagonal pattern in two steps. Refer to [ENGINE UNIT: DISASSEMBLY AND ASSEMBLY ].