LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Grand Vitara Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Power Assisted Steering System) >> Repair Instructions >> Power Steering Oil Pump: Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Steering Oil Pump: Removal and Installation: Removal

WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the power steering fluid from the reservoir tank.
  2. On VQ40DE model, remove the engine room cover. Refer to [ENGINE ROOM COVER: REMOVAL AND INSTALLATION ].
  3. On VQ40DE model, remove cooling fan assembly. Refer to [ENGINE COOLING FAN: REMOVAL AND INSTALLATION (MOTOR DRIVEN TYPE) ].
  4. Remove the air duct assembly. Refer to [AIR CLEANER AND AIR DUCT: EXPLODED VIEW ] (QR25DE), [AIR CLEANER AND AIR DUCT: EXPLODED VIEW ] (VQ40DE).
  5. Remove the serpentine drive belt from the auto tensioner and power steering oil pump. Refer to [DRIVE BELTS: REMOVAL AND INSTALLATION ] (QR25DE), [DRIVE BELTS: REMOVAL AND INSTALLATION ] (VQ40DE).
  6. Disconnect the pressure sensor electrical connector.
  7. Remove the high pressure and low pressure piping from the power steering oil pump. Refer to [HYDRAULIC LINE: REMOVAL AND INSTALLATION ].
  8. Remove the power steering oil pump bolts, then remove the power steering pump.
scientia non olet · About LEMON Manuals