Knuckle: Removal and Installation: Installation

WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

For 4WD models, refer to [DRIVE SHAFT: REMOVAL AND INSTALLATION ] for drive shaft lock nut tightening torque.
CAUTION: Always replace drive shaft lock nut and cotter pin.
Refer to [STEERING GEAR AND LINKAGE: DISASSEMBLY AND ASSEMBLY ] for outer socket nut tightening torque.
Refer to [FRONT SUSPENSION ASSEMBLY: COMPONENT ] for front suspension tightening torques.
When installing disc rotor on wheel hub and bearing assembly, align the marks.

Fig 1: Identifying Alignment Marks On Disc Rotor And Wheel Hub And Bearing Assembly
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: When not using the alignment mark, refer to [SERVICE DATA AND SPECIFICATIONS ].
When installing wheel and tire, refer to [WHEEL AND TIRE ASSEMBLY: ROTATION ]
Perform wheel alignment. Refer to [FRONT WHEEL ALIGNMENT: ON-VEHICLE SERVICE ].