Rear Door Glass: On-Vehicle Repair: Removal

WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear door finisher. Refer to [DOOR FINISHER: REMOVAL AND INSTALLATION ]
Position aside the vapor barrier.
Remove the inside seal.
If equipped, temporarily reconnect the power window switch.
Remove the glass run from the partition glass.
For power windows, operate the power window switch to raise/lower the door window until the glass bolts can be seen.

Fig 1: Locating Rear Door Glass Bolts
Courtesy of SUZUKI OF AMERICA CORP.
For manual windows, temporarily reinstall the window crank handle and lower the window until the glass bolts can be seen.
Remove the partition sash bolt (lower) and screw (upper) to remove the sash.
Remove the bolts and the glass.