Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to TURN SIGNAL AND HAZARD WARNING LAMP SYSTEM: WIRING DIAGRAM .

DIAGNOSIS PROCEDURE CHART

Step	Action	YES	NO
1	CHECK TURN SIGNAL LAMP BULB Check the applicable lamp bulb to be sure the proper bulb standard is in use and the bulb is not open. Is the bulb OK?	GO TO 2	Replace the bulb.
2	CHECK TURN SIGNAL LAMP OUTPUT VOLTAGE Turn the ignition switch OFF. Courtesy of SUZUKI OF AMERICA CORP. Courtesy of SUZUKI OF AMERICA CORP. 2. Disconnect the front combination lamp connectors and the rear combination lamp connector. 3. Turn the ignition switch ON. 4. With turn signal switch operating, check the voltage between the front combination lamp harness connector and ground. 5. With turn signal switch operating, check the voltage between the rear combination lamp harness connector and ground. Is voltage reading as specified?	GO TO 5	GO TO 3
3	CHECK TURN SIGNAL LAMP CIRCUIT FOR OPEN Turn the ignition switch OFF. 2. Disconnect BCM connector M20. 3. Check continuity between the BCM harness connector M20 and the front combination lamps. Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP. 4. Check continuity between the BCM harness connector M20 and the rear combination lamp connectors. Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP. Are continuity results as specified?	GO TO 4	Repair the harnesses or connectors.
4	CHECK TURN SIGNAL LAMP SHORT CIRCUIT Check continuity between the BCM harness connector and ground. Does continuity exist?	Repair the harnesses or connectors.	Replace BCM. Refer to [BCM (BODY CONTROL MODULE): REMOVAL AND INSTALLATION ]
5	CHECK TURN SIGNAL LAMP GROUND CIRCUIT Check continuity between the front combination lamp harness connectors and ground. Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP. 2. Check continuity between the rear combination lamp harness connectors and ground. Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP. Are continuity results as specified?	Replace the malfunctioning lamp.	Repair the harnesses or connectors.