DTC Confirmation Procedure
CAUTION:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out by 2 persons, a driver and a tester, on a level road.
NOTE:
- If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
- Check to make sure that the following conditions are satisfied when using this procedure.
- 4.4 °C (39.9 °F) < ECT < 50 °C (122 °F)
- 4.4 °C (39.9 °F) < IAT < 50 °C (122 °F)
- BARO > 75 kPa (0.8 kgf/cm2, 10.8 psi, 0.75 bar)
- Fuel level < 85%
- Start engine and warm up to normal operating temperature.
- Drive vehicle for 40 km/h (25 mile/h) for 15 min.
- Turn ignition switch to OFF position for 6 hours.