DTC Troubleshooting
P2008 DIAGNOSIS PROCEDURE
| Step | Action | YES | NO |
|---|---|---|---|
| 1 | Was "Engine and Emission Control System Check" performed? | Go to Step 2. | Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK:J24B . |
| 2 | DTC check
Is there DTC(s) other than P2008? |
Go to applicable DTC (s). | Go to Step 3. |
| 3 | IMRC valve motor drive circuit (open) and IMRC valve motor drive circuit (close) check
Are they in good condition? |
Go to Step 4. | Repair or replace defective wire harness. |
| 4 | IMRC valve motor check
Is it in good condition? |
Substitute a known-good ECM and recheck. | Replace IMRC valve, see INTAKE MANIFOLD REMOVAL AND INSTALLATION . |