Cylinder Block Heater Removal and Installation (If Equipped)

Cylinder Block Heater Removal and Installation (If Equipped)

Removal

1) Disconnect negative (-) cable from battery.
2) Drain coolant. Cooling System Draining
3) Remove exhaust manifold cover.
4) Remove engine block heater (1).











Installation

Cylinder Block Heater Inspection (If Equipped)

Reverse removal procedure for installation noting the following.

- Use new cylinder block heater bolts.
- Tighten cylinder block heater bolts (1) to specified torque.

Tightening torque
Cylinder block heater bolt (a): 11 Nm (1.1 kgf-m, 8.5 lbf-ft)





- Refill coolant. Cooling System Refilling
- Check for coolant leaks. Initial Inspection and Diagnostic Overview