Knuckle: Removal and Installation: Installation

Installation is in the reverse order of removal.

• For 4WD models, refer to [DRIVE SHAFT: REMOVAL AND INSTALLATION ] for drive shaft lock nut tightening torque.
  CAUTION: Always replace drive shaft lock nut and cotter pin.
• Refer to [STEERING GEAR AND LINKAGE: DISASSEMBLY AND ASSEMBLY ] for outer socket nut tightening torque.
• Refer to [FRONT SUSPENSION ASSEMBLY: COMPONENT ] for front suspension tightening torques.
• When installing disc rotor on wheel hub and bearing assembly, align the marks.
  Fig 1: Identifying Alignment Marks On Disc Rotor And Wheel Hub And Bearing Assembly

  Courtesy of SUZUKI OF AMERICA CORP.
  NOTE: When not using the alignment mark, refer to [SERVICE DATA AND SPECIFICATIONS ].
• When installing wheel and tire, refer to [WHEEL AND TIRE ASSEMBLY: ROTATION ]
• Perform wheel alignment. Refer to [FRONT WHEEL ALIGNMENT: ON-VEHICLE SERVICE ].