Terminal Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the connector from the component.

Fig 1: Inserting Small Flat-Blade Tool In Slot Below Front Loaded Terminal Position Assurance
Courtesy of SUZUKI OF AMERICA CORP.
Insert a small flat-blade tool in the slot below the front loaded terminal position assurance (TPA) and pry up.
Remove the TPA by pulling it out of the connector.
Push the wire side of the terminal that is being removed toward the connector and hold it in position.

Fig 2: Inserting J 38125-553 On Slight Upward Angle Into Cavity
Courtesy of SUZUKI OF AMERICA CORP.
Insert the J 38125-553 (GM P/N 15315247) on a slight upward angle into the cavity below the terminal to be removed. Ensure that the pointed on the end of the tool is facing the bottom of the terminal and it stays in contact with the terminal until it stops on the plastic terminal retainer. See the release tool cross reference in the Reference Guide of the J-38125 to ensure that the correct release tool is used.

Fig 3: Pulling Wire Out Of Back Of Connector
Courtesy of SUZUKI OF AMERICA CORP.
Gently pry the plastic terminal retainer down and carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is difficult to remove, repeat the entire procedure.