LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Power Assisted Steering System) >> Repair Instructions >> Steering Gear Inner Tie Rod Replacement - Off Vehicle >> Disassembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Disassembly Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Retaining Washer & Steering Linkage Inner Tie Rod Housing (1 Of 2)
G04844045Courtesy of SUZUKI OF AMERICA CORP.
  1. Remove the steering gear boot. Refer to REMOVAL PROCEDURE .
  2. Place the steering gear in a vise.
    CAUTION:

    Do not change the steering gear preload adjustment before moving the inner tie rod from the steering gear. Changing the steering gear preload adjustment before moving the inner tie rod could result in damage to the pinion and the steering gear.

  3. Bend the tabs to release the retaining washer (1).
    CAUTION:

    Refer to PIPE WRENCH POSITIONING NOTICE .

  4. Place a pipe wrench on the rack next to the steering linkage inner tie rod housing (2).
  5. Place a wrench on the flats of the steering linkage inner tie rod housing (2).
  6. Rotate the steering linkage inner tie rod housing (2) counterclockwise while holding the rack stationary until the steering gear inner tie rod separates from the rack.
  7. Remove and discard the retaining washer (1).
scientia non olet · About LEMON Manuals