LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Mechanical) >> Repair Instructions >> Drive Belt Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly. Refer to REMOVAL PROCEDURE .
  2. Install the engine support fixture. Refer to INSTALLATION PROCEDURE 
  3. Remove the engine mount strut bracket. Refer to REMOVAL PROCEDURE .
  4. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  5. Remove the engine splash shield. Refer to ENGINE SPLASH SHIELD REPLACEMENT - RIGHT SIDE .
  6. Remove the right side engine mount bracket. Refer to REMOVAL PROCEDURE .
  7. Lower the vehicle.
    Fig 1: Locating Drive Belt & Belt Idler Pulley
    G04841412Courtesy of SUZUKI OF AMERICA CORP.
  8. Rotate the drive belt tensioner clockwise to release the drive belt tension.
  9. Slide the drive belt off of the belt idler pulley (1).
  10. Slowly release the drive belt tensioner.
  11. Remove the drive belt from the accessory drive pulleys.
scientia non olet · About LEMON Manuals