LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Engine Mechanical) >> Repair Instructions >> Drive Belt Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Drive Belt & Belt Idler Pulley
G04841413Courtesy of SUZUKI OF AMERICA CORP.
  1. Install the drive belt to the crankshaft pulley, the tensioner and the generator.
  2. Rotate the drive belt tensioner clockwise.
  3. Install the drive belt to the idler pulley (1).
    NOTE: Ensure the drive belt is properly aligned and seated into the grooves of the accessory drive pulleys.
  4. Slowly release the drive belt tensioner.
  5. Raise the vehicle.
  6. Install the right side engine mount bracket. Refer to INSTALLATION PROCEDURE .
  7. Install the engine splash shield. Refer to ENGINE SPLASH SHIELD REPLACEMENT - RIGHT SIDE .
  8. Lower the vehicle.
  9. Install the engine mount strut bracket. Refer to INSTALLATION PROCEDURE .
  10. Remove the engine support fixture. Refer to ENGINE SUPPORT FIXTURE .
  11. Install the air cleaner assembly. Refer to INSTALLATION PROCEDURE .
scientia non olet · About LEMON Manuals