Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine. Refer to REMOVAL PROCEDURE .
Remove the right bank secondary timing chain. Refer to SECONDARY CAMSHAFT DRIVE CHAIN REPLACEMENT - RIGHT SIDE .

Fig 1: Identifying Cylinder Head
Courtesy of SUZUKI OF AMERICA CORP.
Remove the cylinder head with the exhaust manifold. Refer to CYLINDER HEAD REMOVAL - RIGHT SIDE .

Fig 2: Identifying Cylinder Head Gasket
Courtesy of SUZUKI OF AMERICA CORP.
Remove and discard the cylinder head gasket.
Clean and inspect the cylinder head and the engine block sealing surfaces. Refer to CYLINDER HEAD CLEANING AND INSPECTION and ENGINE BLOCK CLEANING AND INSPECTION .
If necessary, perform the following steps:
- Remove the exhaust manifold from the cylinder head. Refer to EXHAUST MANIFOLD REMOVAL - RIGHT SIDE .
- Remove the camshaft. Refer to CAMSHAFT REMOVAL - RIGHT SIDE .
- Disassemble the cylinder head. Refer to CYLINDER HEAD DISASSEMBLE .