Wiring Harness Removal

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Reference: CONTROL VALVE BODY COVER REMOVAL .

Fig 1: Identifying Wiring Harness Connectors

Courtesy of SUZUKI OF AMERICA CORP.

NOTE: Do not damage the wiring harness connectors.

Disconnect the wiring harness connectors 1-8.

Fig 2: Identifying Fluid Temperature Sensor Bolt & Clamp
Courtesy of SUZUKI OF AMERICA CORP.
Remove the fluid temperature sensor bolt (31).
Remove the fluid temperature sensor clamp (49).
Remove the fluid temperature sensor (36) and the O-ring (32) from the control valve body assembly.

Fig 3: Removing A/T Control Wiring Harness Connector Retainer
Courtesy of SUZUKI OF AMERICA CORP.
Remove the A/T control wiring harness connector retainer (69).

Fig 4: Identifying Transmission Wiring Harness Assembly & Automatic Transmission Wiring Connector Seal
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: Do not break the wiring harness connectors or the fluid temperature sensor.
Remove the transmission wiring harness assembly (33) from the transmission case assembly through the wiring harness bore.
Remove the TCM seal (72) and the automatic transmission wiring connector seal (46) from the connector.