LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Automatic Transmission) >> Repair Instructions >> Low and Reverse Clutch Piston Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Low and Reverse Clutch Piston Installation

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Low & Reverse Clutch Piston
G04846111Courtesy of SUZUKI OF AMERICA CORP.
  1. Rotate the transmission case so the transmission case cover side is facing up.
  2. Apply automatic transmission fluid to the new seals.
  3. Install the new inner (510) and outer (512) piston seals onto the low and reverse clutch piston (511).
  4. Apply automatic transmission fluid to the seal surfaces of the transmission case.
  5. By hand, press the low and reverse clutch piston (511) into the transmission case until seated. Do not damage the seals.
    Fig 2: Identifying Low & Reverse Clutch Spring Assembly
    G04846112Courtesy of SUZUKI OF AMERICA CORP.
  6. Install the low and reverse clutch spring assembly (513) onto the low and reverse clutch piston (511), indexing the springs to the piston bosses.
    NOTE:
    • Do not damage the inner surface of the transmission case assembly.
    • Position the low and reverse clutch spring retaining ring (514) opening correctly as shown.
  7. While compressing the low and reverse clutch spring (513) by hand, install the low and reverse clutch spring retaining ring (514) into the groove in the transmission case assembly, making sure the open ends face away from any openings.

    Reference: FRONT INTERNAL GEAR AND LOW AND REVERSE CLUTCH INSTALLATION .

scientia non olet · About LEMON Manuals