Diagnosis Procedure

Regarding Wiring Diagram information, refer to [CHARGING SYSTEM: WIRING DIAGRAM ].

Step	Action	YES	NO
1	CHECK CHARGE WARNING LAMP CIRCUIT CONNECTION  Verify generator connector E205 terminal 2 is clean and tight. Is the connection secure?	GO TO 2	Repair the connection. Confirm repair by performing complete Starting/Charging system test. Refer to Technical Service Bulletin.
2	CHECK CHARGE WARNING LAMP CIRCUIT  Disconnect generator connector E205. Apply ground to generator harness connector E205 terminal 2 with the ignition switch in the ON position. Courtesy of SUZUKI OF AMERICA CORP. Charge lamp should illuminate  Does the charge lamp illuminate?	Check generator function. Refer to [DIAGNOSIS AND REPAIR WORKFLOW ].	GO TO 3
3	CHECK HARNESS CONTINUITY  Turn ignition switch OFF. Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP. 2. Disconnect the combination meter connector M24. 3. Check continuity between generator harness connector E205 (A) terminal 2 and combination meter harness connector M24 (B) terminal 2. Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP. 4. Check continuity between generator harness connector E205 (A) terminal 2 and ground. Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP. Are the continuity results as specified?	Replace the combination meter. Refer to [COMBINATION METER: REMOVAL AND INSTALLATION ]	Repair the harness or connector.