LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2010 >> SX4 Base, Standard >> Repair and Diagnosis >> Transmission >> Transfer Case >> Repair Instructions >> Transfer Dismounting and Remounting >> Dismounting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transfer Dismounting and Remounting: Dismounting

  1. Disconnect negative (-) cable at battery.
  2. Drain the following oils and fluids.
    • Manual transaxle oil (M/T model):
    • CVT fluid (CVT model):
    • Transfer oil:
    • P/S fluid (Hydraulic P/S model):
  3. Remove right side drive shaft assembly.
  4. Remove propeller shaft.
  5. Carry out Step 2) to 13) of "Removal" under FRONT SUSPENSION FRAME, STABILIZER BAR AND/OR BUSH REMOVAL AND INSTALLATION (2WD MODEL) .
  6. Remove engine rear mounting.
  7. Disconnect breather hose (1).
  8. Remove transfer stiffener (2), transfer bolts and transfer nut.
  9. Separate transfer (3) from transaxle.
    CAUTION: When removing transfer, be careful not to drop it. Otherwise, transfer damage and personal injury may result.
    Fig 1: Identifying Transfer And Breather Hose
    G06867397Courtesy of SUZUKI OF AMERICA CORP.
  10. Lower front suspension frame with steering gear case and transfer, and then remove transfer.
  11. Remove O-ring (1) and dowel pin (2).
    Fig 2: Identifying O-Ring And Dowel Pin
    G06867398Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals