DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out by 2 persons, a driver and a tester, on a level road.
NOTE:
If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
- With ignition switch turned OFF, connect scan tool to DLC.
- Turn ON ignition switch and clear DTC.
- Start engine and warm up to normal operating temperature.
- Press cruise MAIN (ON/OFF) switch once.
- Drive vehicle at 40 km/h (25 mph) or higher for 3 min. or more.
- Stop vehicle.
- Check DTC.