Power Balance Test

CAUTION:

Never increase engine speed higher than idling speed when power balance test has been performed. It could damage the engine.
Be careful not to accumulate foreign materials (like dust and metallic particle) to engine. It could damage the engine.

NOTE: For identification of each cylinder, refer to PRECAUTIONS FOR IDENTIFICATION OF CYLINDER .

For CVT model, place select lever in "P" and apply parking brake.
For M/T model, place gear shift lever in "Neutral" and apply parking brake.
Warm up engine to normal operating temperature.
Remove engine cover. See AIR CLEANER ASSEMBLY REMOVAL AND INSTALLATION
Disconnect fuel injector connector (1) for cylinder No. 1.

Fig 1: Identifying Fuel Injector Connector For Cylinder No. 1
Courtesy of SUZUKI OF AMERICA CORP.
Check that engine speed decreases from specified idle speed.
Repeat Step 4) and Step 5) for all cylinders, compare rates of engine speed decrease.
If rates of engine speed decrease are not in scale, check the following items.
- Fuel injector circuit see Fuel Injector Circuit Check
- Fuel injector see Fuel Injector Inspection
- Spark plug see SPARK PLUG INSPECTION
- Ignition coil circuit see IGNITION SYSTEM CHECK
- Ignition coil see IGNITION COIL ASSEMBLY INSPECTION
Clear DTC. See DTC CLEARANCE
Install engine cover. See AIR CLEANER ASSEMBLY REMOVAL AND INSTALLATION