Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor Removal and InstallationRemoval
1. Disconnect negative cable at battery.
2. Remove generator.
3. Disconnect CKP sensor connector.
4. Remove CKP sensor (1) from cylinder block.
Installation
Reverse removal procedure noting the following.
- Apply engine oil to O-ring of sensor.
- Tighten CKP sensor bolt to specified torque.
Tightening torque
CKP sensor bolt (a): 11 N.m (1.1 kg-m, 8.0 lbf-ft)
- Connect connector and fix wire harness with clamp securely.