P2097

DTC P2096 / P2097

System and Wiring Diagram

Wiring Diagram:

Wiring Diagram:

DTC Detecting Condition and Trouble Area

DTC Confirmation Procedure

WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out by 2 persons, a driver and a tester, on a level road.

NOTE:
- If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
- Check that the following conditions are satisfied when using this procedure.
- ECT > 65 °C (149 °F)

1. Warm up engine to normal operating temperature.
2. Drive vehicle at 60 km/h (38 mile/h) or higher for 4 min.

DTC Troubleshooting

Step 1-2:

Step 3-8:

Step 9-13: