DTC Troubleshooting

DIAGNOSTIC PROCEDURES CHART

Step	Action	YES	NO
1	Was "Engine and Emission Control System Check" performed?	Go to Step 2.	Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK .
2	EVAP leak check pressure sensor check Check EVAP leak check pressure sensor for performance referring to "EVAP LEAK CHECK PRESSURE SENSOR (COMBINE WITH BARO SENSOR) ON-VEHICLE INSPECTION " under EVAP Leak Check Module Inspection . Is it in good condition?	Go to Step 3.	Replace EVAP leak check module, see EVAP CANISTER REMOVAL AND INSTALLATION .
3	EVAP system check Check the following parts for clogging. EVAP canister EVAP canister air suction filter EVAP passage EVAP vent valve in EVAP leak check module Are they in good condition?	Go to Step 4.	Clean, repair or replace defective parts.
4	EVAP leak check pressure sensor circuit check Check EVAP leak check pressure sensor circuit according to step 2 through 5 of DTC P2228/P2229 . Is it in good condition?	Replace ECM and recheck DTC., see ECM REMOVAL AND INSTALLATION .	Repair or replace defective wire harness.