DTC Confirmation Procedure
WARNING:
- Perform road test in a place where there is no traffic to prevent an accident.
- Road test should be performed by two persons, a driver and a tester, on a level road.
NOTE:
- Be sure to troubleshoot first unexpected DTCs previously detected in "DTC Confirmation Procedure".
- Confirm that the following conditions are met in this "DTC Confirmation Procedure".
- DTC P0102, P0103, P0131, P0132, P0137, P0138, P0171, P0172 or P2237 is not detected.
- Connect scan tool with ignition mode of keyless push start system in "OFF".
- Warm up engine to normal operating temperature.
- Drive vehicle at 100 km/h (62 mile/h) for 10 min.