DTC Troubleshooting
DIAGNOSTIC PROCEDURES CHART
| Step | Action | YES | NO |
|---|---|---|---|
| 1 | Was "Engine and Emission Control System Check" performed? | Go to Step 2. | Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK . |
| 2 | DTC check
Is there DTC(s) other than P0139 and P013E? |
Go to troubleshooting for applicable DTC(s). | Go to Step 3. |
| 3 | HO2S signal circuit and ground circuit check
Are they in good condition? |
Go to Step 4. | Repair or replace defective wire. |
| 4 | DTC recheck
Is DTC P0139 and/or P013E still detected? |
Replace ECM and recheck DTC, see ECM REMOVAL AND INSTALLATION . | End. |