LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2010 >> Kizashi SLS, FWD, Automatic CVT >> Repair and Diagnosis >> Engine Performance >> System >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0560 >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DIAGNOSTIC PROCEDURES CHART

Step Action YES NO
1  Was "Engine and Emission Control System Check" performed?  Go to Step 2. Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK .
2  Back-up power supply circuit check 
  1. Confirm that ignition mode of keyless push start system is "OFF".
  2. Disconnect "C01" and "E01" connectors.
  3. Check for proper terminal connection to "C01" and "E01" connectors.
  4. If connections are OK, check that "F1" circuit and ground is battery voltage with ignition mode of keyless push start system in "ON".

Is it in good condition? 		 Check for intermittent trouble, see INTERMITTENT CONNECTION AND POOR CONTACT INSPECTION .
If OK, replace ECM and recheck DTC, see ECM REMOVAL AND INSTALLATION .		 "B/U" or "DOME" fuse blown, "F1" circuit is open or short to ground circuit, or charging system faulty.
scientia non olet · About LEMON Manuals