LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2010 >> Kizashi SLS, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) >> Diagnostic Information and Procedures >> DTC Clearance >> Permanent DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Permanent DTC

  1. Confirm that ignition mode of keyless push start system is in "OFF".
  2. Connect CAN communication OBD generic scan tool or SUZUKI scan tool to DLC.
  3. Push engine switch to change ignition mode to "ON".
  4. Clear pending and confirmed DTCs.
  5. Select "Permanent DTC" display mode on scan tool. (Refer to scan tool operator's manual for details.)
  6. Execute corresponding DTC confirmation procedure in DTC diagnostic flow and confirm that pending and current DTCs cannot be detected. At this time, if DTC confirmation procedure does not satisfy any of the following conditions, execute DTC confirmation procedure so as to satisfy such condition.
    • Engine operated for more than 12 minutes.
    • Vehicle driven for more than 6 minutes at more than 45 km/h (28 mile/h).
    • Engine idled for more than 1 minute.
  7. Display permanent DTC on scan tool and check that permanent DTC is cleared. If permanent DTC has not been cleared, repeat Step  5) again.
scientia non olet · About LEMON Manuals