DTC Confirmation Procedure
WARNING:
- Perform road test in a place where there is no traffic to prevent an accident.
- Road test should be performed by two persons, a driver and a tester, on a level road.
NOTE:
- Be sure to troubleshoot first unexpected DTCs previously detected in "DTC Confirmation Procedure".
- Confirm that the following conditions are met in this "DTC Confirmation Procedure".
- Battery voltage >= 11 V
- 4.4 °C (39.9 °F) < IAT < 35 °C (95 °F)
- 4.4 °C (39.9 °F) < ECT < 35 °C (95 °F)
- BARO > 75 kPa (0.8 kgf/cm2 , 10.8 psi, 0.75 bar)
- Fuel level < 85%
- DTC P2228 or P2229 is not detected.
- Warm up engine to normal operating temperature.
- Drive vehicle for 40 km/h (25 mile/h) for 15 min.
- Push engine switch to change ignition mode to "OFF" and leave ignition mode in "OFF" for 5 hours.