LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2010 >> Kizashi SLS, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> DTC P0532/P0533 >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DIAGNOSTIC PROCEDURES CHART

Step Action YES NO
1  Was "Engine and Emission Control System Check" performed?  Go to Step 2. Go to ENGINE AND EMISSION CONTROL SYSTEM CHECK .
2  A/C refrigerant pressure sensor power supply circuit check 
  1. Confirm that ignition mode of keyless push start system is "OFF".
  2. Disconnect connector from A/C refrigerant pressure sensor.
  3. Check for proper terminal connection to A/C refrigerant pressure sensor connector.
  4. If connections are OK, check that voltage between "A1" and "A3" circuits are 5 V with ignition mode of keyless push start system in "ON".

Are they in good condition? 		 Go to Step 5. Go to Step 3.
3  A/C refrigerant pressure sensor ground circuit check 
  1. Check that voltage between "A1" circuit and ground is 5 V.

Is it in good condition? 		 Repair or replace "A3" circuit.
If this DTC is detected again, replace ECM and recheck DTC, see ECM REMOVAL AND INSTALLATION .		 Go to Step 4.
4  A/C refrigerant pressure sensor power supply circuit check 
  1. Push engine switch to change ignition mode to "OFF".
  2. Disconnect "C01" and "E01" connectors.
  3. Check for proper terminal connection to "C01" and "E01" connectors.
  4. If connections are OK, check the following points.
    • Resistance of "A1" circuit: less than 1 Ω
    • Resistance of "A1" circuit between A/C refrigerant pressure sensor connector and ground: infinity
    • Resistance of between "A1" circuit terminal and other terminal at A/C refrigerant pressure sensor connector: infinity
    • Voltage of "A1" circuit: 0 - 1 V (with ignition mode of keyless push start system in "ON")

Are they in good condition? 		 Replace ECM and recheck DTC, see ECM REMOVAL AND INSTALLATION . Repair or replace defective wire harness.
5  A/C refrigerant pressure sensor signal circuit check 
  1. Push engine switch to change ignition mode to "OFF".
  2. Disconnect "C01" and "E01" connectors.
  3. Check for proper terminal connection to "C01" and "E01" connectors.
  4. If connections are OK, check the following points.
    • Resistance of "A2" circuit: less than 1 Ω
    • Resistance of "A2" circuit between A/C refrigerant pressure sensor connector and ground: infinity
    • Resistance of between "A2" circuit terminal and other terminal at A/C refrigerant pressure sensor connector: infinity
    • Voltage of "A2" circuit: 0 - 1 V (with ignition mode of keyless push start system in "ON")

Are they in good condition? 		 Go to Step 6. Repair or replace defective wire harness.
6  A/C refrigerant pressure sensor check 
  1. Check A/C refrigerant pressure sensor, see A/C REFRIGERANT PRESSURE SENSOR AND ITS CIRCUIT INSPECTION .

Is it in good condition? 		 Replace ECM and recheck DTC, see ECM REMOVAL AND INSTALLATION . Replace A/C refrigerant pressure sensor.
scientia non olet · About LEMON Manuals