DTC Confirmation Procedure
WARNING:
- Perform road test in a place where there is no traffic to prevent an accident.
- Road test should be performed by two persons, a driver and a tester, on a level road.
NOTE:
- Be sure to troubleshoot first unexpected DTCs previously detected in "DTC Confirmation Procedure".
- Confirm that the following conditions are met in this "DTC Confirmation Procedure".
- DTC P0010, P0335 or P0340 is not detected.
- Connect scan tool with ignition mode of keyless push start system in "OFF".
- Warm up engine to normal operating temperature.
- Drive vehicle for 30 sec. at throttle opening 30% or more checking the opening with scan tool.