DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out by 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this procedure.
- ECT at engine starting > 110 °C (230 °F)
- Start engine and warm up to normal operating temperature.
- Drive vehicle at 50 - 60 km/h (31 - 37 mph) for 1 min. or more. (Keep throttle valve opening constant in this step.)
- Stop vehicle, and run engine at idle speed for 30 sec. or more.
- Repeat Step 2) through 3) for 4 times.