LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2010 >> Grand Vitara Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - 4AT >> Diagnostic Information and Procedures >> DTC P0962: Pressure Control Solenoid "A" Control Circuit Low >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC TROUBLESHOOTING CHART

Step Action YES NO
Was "A/T System Check" performed?  Go to Step 2. Go to A/T SYSTEM CHECK .
Check pressure control solenoid valve circuit for ground short 
  1. Disconnect TCM connectors.
  2. Check for proper connection to TCM at terminals "E92-2" and "E92-4".
  3. If connection is OK, check continuity between terminal "E92-2" of disconnected harness side TCM connector and ground.

Is continuity indicated? 
Pressure control solenoid valve circuit is shorted to ground. If circuit is OK, go to Step 4. Go to Step 4.
Check pressure control solenoid valve circuit for open 
  1. Check resistance between terminals "E92-2" and "E92-4" of disconnected harness side TCM connector.

Is it infinity? 
Pressure control solenoid valve circuit is open circuit. If circuit is OK, go to Step 4. Go to Step 4.
Check pressure control solenoid valve 
  1. Check pressure control solenoid valve referring to SOLENOID VALVES (SHIFT SOLENOID-A, SHIFT SOLENOID-B, TCC PRESSURE CONTROL SOLENOID AND PRESSURE CONTROL SOLENOID) INSPECTION .

Is check results satisfactory? 
Intermittent trouble or faulty TCM. Check for intermittent trouble referring to INTERMITTENT AND POOR CONNECTION INSPECTION . If OK, substitute a known-good TCM and recheck. Replace defective pressure control solenoid valve referring to SOLENOID VALVES (SHIFT SOLENOID-A, SHIFT SOLENOID-B, TCC PRESSURE CONTROL SOLENOID AND PRESSURE CONTROL SOLENOID) REMOVAL AND INSTALLATION .