Transmission Fluid Temperature Sensor Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.

Perform Step 1) to 7) of SOLENOID VALVES (SHIFT SOLENOID-A, SHIFT SOLENOID-B, SHIFT SOLENOID-E, TCC PRESSURE CONTROL SOLENOID, PRESSURE CONTROL SOLENOID-A, PRESSURE CONTROL SOLENOID-B AND PRESSURE CONTROL SOLENOID-C) REMOVAL AND INSTALLATION .
Remove transmission fluid temperature sensor (8).
Disconnect shift solenoid-A connector (1), shift solenoid-B connector (2), shift solenoid-E connector (3), TCC pressure control solenoid connector (4), pressure control solenoid-A connector (5), pressure control solenoid-B connector (6) and pressure control solenoid-C connector (7).
Remove solenoid valves.

Fig 1: Identifying Shift Solenoid, TCC Pressure Control Solenoid And Pressure Control Solenoid Connectors
Courtesy of SUZUKI OF AMERICA CORP.
After removing bolt (1) pull out solenoid connector (2) from transmission case.
CAUTION: When pulling solenoid wire harness out of transmission case, take care not to damage connectors and transmission fluid temperature sensor at narrow exist of case. Careless sensor treatment might cause sensor malfunction.

Fig 2: Identifying Solenoid Connector And Bolt
Courtesy of SUZUKI OF AMERICA CORP.