| 1 |
CHECK WAIT DETECTION SWITCH SIGNAL
- With SDT
- Start engine.
- Select "Data list" mode for "4WD" with SDT.
- Read out the value of "WAIT DETCT SW".
   Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
- 2)
Without SDT
- Start engine.
- Check voltage between transfer control unit harness connector terminal and ground.
Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
Are the inspection results normal? |
GO TO 5. |
GO TO 2. |
| 2 |
CHECK HARNESS BETWEEN TRANSFER CONTROL UNIT AND WAIT DETECTION SWITCH
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Disconnect transfer control unit harness connector and the wait detection switch harness connector.
- Check continuity between transfer control unit harness connector M152 terminal 17 and wait detection switch harness connector F59 terminal 10.
 Courtesy of SUZUKI OF AMERICA CORP.
Continuity should exist.
Also check harness for short to ground and short to power.
Is there continuity? |
GO TO 3. |
Repair or replace damaged parts. |
| 3 |
CHECK GROUND CIRCUIT
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Disconnect wait detection switch harness connector.
- Check continuity between wait detection switch harness connector F59 terminal 11 and ground.
 Courtesy of SUZUKI OF AMERICA CORP.
Continuity should exist.
Also check harness for short to power.
Is there continuity? |
GO TO 4. |
Repair open circuit or short to power in harness or connectors. |
| 4 |
CHECK WAIT DETECTION SWITCH
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Disconnect wait detection switch harness connector.
- Remove wait detection switch. Refer to
[4WD SYSTEM: COMPONENT PARTS LOCATION ].
- Push and release wait detection switch and check continuity between wait detection switch terminals 10 and 11.
  Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
Courtesy of SUZUKI OF AMERICA CORP.SUZUKI OF AMERICA CORP.
Are the inspection results normal? |
GO TO 5. |
Replace wait detection switch. |
| 5 |
CHECK TRANSFER CONTROL UNIT
Check transfer control unit input/output signal. Refer to
[TRANSFER CONTROL UNIT: REFERENCE VALUE ].
Are the inspection results normal? |
GO TO 6. |
Check transfer control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts. |
| 6 |
CHECK DTC
Drive the vehicle and then perform "DTC check".
Is DTC P1814 displayed? |
Replace transfer control unit. Refer to
[TRANSFER CONTROL UNIT: REMOVAL AND INSTALLATION ]. |
Inspection End. |