LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2010 >> Equator Base, 4D Pickup >> Repair and Diagnosis >> Transmission >> Automatic Transmission/Transaxle >> Diagnostic information and Procedures >> DTC P0732 A/T 2nd Gear Function >> DTC Confirmation Procedure >> With SDT
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With SDT

  1. Start the engine and select "Data list" mode for "AT" with SDT.
  2. Make sure that "ATF TEMP 1" is within the following range.

    ATF TEMP 1: 20 °C - 180 °C 

    If out of range, drive vehicle to warm ATF or stop engine to cool ATF.

  3. Select "2ND GR FNCTN P0732" of "DTC work support" mode for "AT" with SDT.
  4. Drive vehicle and maintain the following conditions.

    SLCT LVR POSI: "2" position 

    GEAR: "2" position 

    ACCELE POSI: 0.6/8 or more 

    VEHICLE SPEED: 10 km/h (6 MPH) or more 

    ENGINE SPEED: TURBINE REV - 50 RPM or more 

    TURBINE REV: 300 RPM or more 

  5. Keep the current driving status for at least 5 consecutive seconds if SDT screen changes from "OUT OF CONDITION" to "TESTING".
    CAUTION: If "TESTING" does not appear on SDT for a long time, select "DTC check". In case a 1st trip DTC other than P0732 is shown, refer to [SDT FUNCTION (AT) ].

    If "COMPLETED RESULT NG" is detected, go to [DTC P0732 A/T 2ND GEAR FUNCTION ]. If "STOP VEHICLE" is detected, go to the following step.

  6. Stop vehicle.
  7. Drive vehicle in "D" position allowing it to shift from 1st to 5th gear and check shift timing and shift shock.
    • Touch "OK" to complete the inspection when normally shifted from the 1st to 5th gear.
    • Touch "NG" when an unusual shift shock, etc. occurs in spite of shifting from the 1st to 5th gear. Go to [ROAD TEST ].
    • Perform [SDT FUNCTION (AT) ] when not shifted from the 1st to 5th gear. (Neither "OK" nor "NG" are indicated.)
scientia non olet · About LEMON Manuals