LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Premium, FWD >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Front Suspension >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

Fig 1: Maneuvering Stabilizer Shaft (1) So It's Positioned Between Wheel Drive Shaft (3) And Front Lower Control Arm (2)
G00425715Courtesy of SUZUKI OF AMERICA CORP.
NOTE: Take care not to catch the transmission shift cable or left wheel house plastic trim when removing/installing the stabilizer shaft.
  1. Position the stabilizer shaft (1) so that it is positioned between the wheel drive shaft (3) and the front lower control arm (2).
  2. Maneuver the stabilizer shaft until it is properly position on the frame.
    3. Fig 2: Identifying Stabilizer Shaft Clamp Bolts
    G04842720Courtesy of SUZUKI OF AMERICA CORP.
  3. Install the stabilizer shaft bushing and clamps.
    CAUTION: Refer to FASTENER NOTICE .
  4. Install the stabilizer shaft clamp retaining bolts.

    Tightening torque 

    Tighten the bolts to 50 N.m (37 lb ft)  .

    5. Fig 3: Identifying Stabilizer Shaft Link Ball Stud
    G04842721Courtesy of SUZUKI OF AMERICA CORP.
  5. Install the stabilizer shaft links. Refer to STABILIZER SHAFT LINK REPLACEMENT .
  6. Install the outer tie rod ends. Refer to RACK AND PINION OUTER TIE ROD END REPLACEMENT .
  7. Install the front tire and wheels. Refer to INSTALLATION PROCEDURE .
  8. Remove the support.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals