LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Premium, AWD >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Diagnostic Information and Procedures >> DTC P0850-P0852: Park/Neutral Position (PNP) Switch Circuit >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the 20-way harness connector at the transmission.
  2. Install the DT-47825-20 to the 20-way harness connector to the engine harness.
  3. Test for less than 10 ohms between the ground circuit terminal 18 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Ignition ON, test for B+ between the adapter harness terminal 20 and ground.
    • If not within the specified range, test the park/neutral signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. Ignition OFF, install the DT-47825-20 to the 20-way harness connector at the transmission.
  6. Gear shift lever in Park, test for less than 1 ohm between the adapter harness pins 18 and 20.
    • If greater than the specified range, test the shaft position switch assembly. Refer to COMPONENT TESTING . If the shaft position switch assembly tests normal, replace the control solenoid (w/body and TCM) valve assembly.
  7. Gear shift lever in D (drive), test for infinite resistance between the adapter harness pins 18 and 20.
    • If not the specified value, test the shaft position switch assembly, refer to COMPONENT TESTING . If the switch assembly test normal, replace the control solenoid (w/body and TCM) valve assembly.
  8. If all circuits test normal, replace the ECM.
scientia non olet · About LEMON Manuals