Inflatable Restraint Vehicle Rollover Sensor Scan Tool Information
WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Rollover Sensor Scan Tool Data Parameters
ROLLOVER SENSOR SCAN TOOL DATA PARAMETERS
| Parameter | Expected Value | Definition |
|---|---|---|
| Operating Conditions: Ignition ON | ||
| Average Speed | Varies | This displays km/h (mph). This is the average speed of the vehicle. |
| Battery Voltage Signal | Varies | This displays volts. This is the voltage input supplied to the rollover sensor. |
| Current Power Mode | Run | The scan tool displays Off, Accessory, Run or Crank Request. This is the state of the ignition switch. |
| Engine Virtual Device | Present | The scan tool displays Present or Not Present. |
| Primary Key Status | Valid | The scan tool displays Unknown, Valid or Invalid. This is the state of the primary key. |
| Received Primary Key | Varies | The scan tool displays the primary key received. |
| ROS Occupant Containment Req. | Enable | The scan tool displays Reserved, Disable or Enable. |
| ROS Primary Key | Varies | The scan tool displays the ROS primary key. |
| SDM Occupant Containment Status | Enabled | The scan tool displays Disabled or Enabled. |
| Vehicle Speed Status | Valid | The scan tool displays Valid or Invalid. This is the state of the vehicle speed. |
Instrument Panel Cluster Scan Tool Output Controls
INSTRUMENT PANEL CLUSTER SCAN TOOL OUTPUT CONTROLS DESCRIPTION
| Scan Tool Output Control | Description |
|---|---|
| Setup New ROS | This procedure should be used after a new rollover sensor has been installed. |