Circuit/System Testing
WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected.
- ROS
- ROS wiring harness
- Verify the correct ROS part number has been installed
- If the wrong ROS part number was installed, replace with the correct ROS.
- Verify that DTC B1001 is not set in the ROS.
- If DTC is set, perform the Setup New ROS procedure. If DTC resets replace the ROS.