Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

If necessary, perform the following steps:
- Assemble the cylinder head. Refer to CYLINDER HEAD ASSEMBLE .
- Install the camshaft. Refer to CAMSHAFT INSTALLATION - RIGHT SIDE .
- Install the exhaust manifold to the cylinder head. Refer to EXHAUST MANIFOLD INSTALLATION - RIGHT SIDE .
  
  Fig 1: Identifying Cylinder Head Gasket
  Courtesy of SUZUKI OF AMERICA CORP.
Install a NEW cylinder head gasket.

Fig 2: Identifying Cylinder Head With Exhaust Manifold
Courtesy of SUZUKI OF AMERICA CORP.
Using the aid of an assistant, carefully install the cylinder head with the exhaust manifold to the engine. Refer to CYLINDER HEAD INSTALLATION - RIGHT SIDE .
Install the power steering hose retainer.
Connect and clip the HO2 sensor wiring harness.
Install the ground wires to the cylinder head.
Install the right side catalytic converter. Refer to CATALYTIC CONVERTER REPLACEMENT - RIGHT SIDE .
Install the right bank secondary timing chain. Refer to SECONDARY CAMSHAFT DRIVE CHAIN REPLACEMENT - RIGHT SIDE .