PNP Switch Malfunction
- Inspect the range selector lever cable for proper adjustment. Refer to RANGE SELECTOR LEVER CABLE ADJUSTMENT in the Automatic Transmission article.
- Ignition OFF, disconnect the harness connector at the transmission inline 20-way connector.
- Ignition ON, test for greater than 5 V between the signal circuit terminal 5 X1 and ground.
- If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
- Ignition OFF, remove the control valve body cover. Refer to Control Valve Body Cover Replacement.
- Connect the transmission inline 20-way connector. Disconnect the shift position switch from the TCM.
- Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 Ω between the ground circuit terminal A of the TCM and ground.
- If greater than the specified range, test the TCM ground circuit for an open/high resistance. If the circuit tests normal, replace the TCM.
- Ignition ON, verify the scan tool ECM PNP Switch parameter is In Gear.
- If not the specified value, test the signal circuit terminal F for a short to ground. If the circuit tests normal, replace the ECM.
- Install a 3 A fused jumper wire between the signal circuit terminal F and ground. Verify the scan tool ECM PNP Switch parameter is Park/Neutral.
- If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
- If all circuits test normal, test or replace the internal mode switch.