LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Premium, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Wiper/Washer Systems >> Wipers/Washers >> Diagnostic Information and Procedures >> DTC B3922: Front Wiper Function Select Circuit >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the windshield wiper switch.
  2. Ignition OFF, test for less than 20 ohms of resistance between the ground circuit terminal D and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance. If the circuit test normal, replace the BCM.
  3. Ignition ON, verify the scan tool Windshield Wiper Switch parameter is Off.
    • If not the specified value, test the signal circuit terminal E for a short to ground. If the circuit tests normal, replace the BCM.
  4. Install a 3A fused jumper wire between the signal circuit terminal E and ground. Verify the scan tool Windshield Wiper Switch parameter is Switch Fault.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the windshield wiper washer switch.
scientia non olet · About LEMON Manuals