Component Testing

NOTE: The cruise control switch must be ON in order to properly measure the resistance of the - SET, + RES or Cancel switches.

Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.
Measure the resistance between terminals 1 and 3 at the cruise control switch side of the connector. Individually activate and hold each cruise control function switch and compare the resistance reading to the values for the On, Off, SET -, RES + and Cancel switches.
- If any of the resistance measurements for the On, Off, SET -, RES + and Cancel switches are not within the listed resistance values, replace the steering wheel controls switch - left.

RESISTANCE VALUE SPECIFICATION