LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Limited, FWD >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Diagnostic Information and Procedures >> DTC P0716 or P0717: Input Speed Sensor >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, remove the control valve body cover. Refer to CONTROL VALVE BODY COVER REPLACEMENT .
  2. Connect the TCM harness connector.
  3. Disconnect the input speed sensor (ISS) from the control solenoid (w/body and TCM) valve assembly.
  4. Connect the J 38522 between the supply voltage terminal B and ISS signal terminal A at the control solenoid (w/body and TCM) valve assembly. Refer to CONTROL SOLENOID VALVE AND TRANSMISSION CONTROL MODULE ASSEMBLY INPUT SHAFT SPEED/OUTPUT SHAFT SPEED INPUT TEST  for further instructions.
  5. Set the J 38522 signal to 8 volts, the frequency to 120 and the percent duty cycle to 50.
  6. Ignition ON, observe the scan tool Transmission ISS parameter. The scan tool Transmission ISS parameter should be between 100-400 RPM.
    • If not within the specified range, replace the control solenoid (w/body and TCM) valve assembly.
  7. If all circuits test normal, test or replace the input speed sensor.
scientia non olet · About LEMON Manuals