Inadvertent Power Courtesy Lamps Circuit Test
WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the X3 harness connector at the BCM.
- Verify that a test lamp illuminates between the B+ circuit terminal 2 and ground.
- If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal and the B+ circuit fuse is open, test the inadvertent power courtesy lamp circuit for a short to ground.
- Ignition OFF, connect the harness connector at the BCM.
- Disconnect the harness connector at the inoperative lamp.
- Test for less than 5.0 ohms of resistance between the appropriate ground circuit terminal listed below and ground.
- Dome lamp - terminal B
- Courtesy/map lamp - terminal D
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the inadvertent power courtesy lamp circuit terminal and ground.
- Dome lamp - terminal C
- Courtesy/map lamp - terminal A
- If the test lamp does not illuminate, test the inadvertent power courtesy lamp circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
- If all circuits test normal, replace the inoperative lamp.