Inflatable Restraint Side Impact Sensor Replacement

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Inflatable Restraint Side Impact Sensor

Courtesy of SUZUKI OF AMERICA CORP.

COMPONENT REFERENCE

Callout	Component Name
WARNING: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR DISABLING AND ENABLING . Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs. WARNING: Do not strike or jolt the inflatable restraint side impact sensor (SIS). Before applying power to the SIS make sure that it is securely fastened. Failure to observe the correct installation procedures could cause SIR deployment, personal injury, or unnecessary SIR system repairs. Fastener Tightening Specifications: Refer to FASTENER TIGHTENING SPECIFICATIONS - SIR .Preliminary Procedures Disable the SIR system. Refer to SIR DISABLING AND ENABLING . Remove the center pillar lower molding. Refer to CENTER PILLAR LOWER GARNISH MOLDING REPLACEMENT
1	Inflatable Restraint Side Impact Sensor Bolt (Qty: 2) Tightening torque 10 N.m (89 lb in)
2	Inflatable Restraint Side Impact Sensor Slide sensor into grooves in sheet metal to ensure proper seating of sensor against body. Disconnect electrical connector.