Electronic Brake Control Module Replacement

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Electronic Brake Control Module Components

Courtesy of SUZUKI OF AMERICA CORP.

COMPONENT NAME CHART

Callout	Component Name
Preliminary Procedures Place the ignition switch in the OFF position. Remove the underhood electrical center bracket. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK BRACKET REPLACEMENT . Clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any dirt or debris.
1	Electronic Brake Control Module (EBCM) Electrical Connector Tip: Release the locking tab and rotate the electrical connector cover upward to release.
2	EBCM to Brake Pressure Modulator Valve (BPMV) Screw (Qty: 4) CAUTION: Refer to FASTENER NOTICE . Tip: Tighten the screws in a cross pattern. Tightening torque 3 N.m (27 lb in)
3	Electronic Brake Control Module
4	EBCM to BPMV Seal (Qty: 12) If installing a new EBCM, program the EBCM. Refer to CONTROL MODULE REFERENCES . Without starting the engine, place the ignition switch in the ON position. Perform the DIAGNOSTIC SYSTEM CHECK - VEHICLE DIAGNOSTIC INFORMATION . Observe the feel of the brake pedal after performing the diagnostic system check. If the pedal now feels spongy, air may have been in the secondary circuit of the brake modulator assembly, which may have been introduced into the primary circuit. If the pedal feels spongy, perform the ANTILOCK BRAKE SYSTEM AUTOMATED BLEED PROCEDURE .