Brake Pressure Modulator Valve Bracket Replacement

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Pressure Modulator Valve Bracket Components

Courtesy of SUZUKI OF AMERICA CORP.

COMPONENT NAME CHART

Callout	Component Name
Preliminary Procedures Place the ignition switch in the OFF position. Remove the underhood electrical center bracket. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK BRACKET REPLACEMENT .
1	Brake Modulator Assembly Bracket Bolt CAUTION: Refer to FASTENER NOTICE . Tightening torque 20 N.m (15 lb ft)
2	Brake Modulator Assembly Bracket Nut (Qty: 2) Tightening torque 10 N.m (89 lb in)
3	Brake Modulator Assembly Bracket Tip: Without disconnecting the brake pipe fittings, carefully remove and support the brake modulator assembly.