LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2009 >> XL7 Limited, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Instrumentation/Driver Info./Horn) >> Diagnostic Information and Procedures >> DTC P0463 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the fuel level sensors.
  2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal B and ground.
    • If greater than the specified, test the low reference circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition OFF, test for less than 1 ohm between the fuel level sensor signal circuit terminal C and the fuel level sensor signal circuit terminal E.
    • If greater than the specified, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  4. Ignition ON, install a 3A fused jumper between the signal circuit terminal D and the low reference circuit terminal B. Verify the scan tool Fuel Tank Level Remaining parameter is greater than 98 percent.
    • If less than 98 percent, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
  5. If all circuits test normal, test or replace the fuel level sensors.
scientia non olet · About LEMON Manuals