Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Remove the compressor from the vehicle. Refer to COMPRESSOR REPLACEMENT .

Fig 1: Identifying Compressor From Vehicle
Courtesy of SUZUKI OF AMERICA CORP.
Use J 37872 to hold the compressor clutch.

Fig 2: Holding Compressor Clutch
Courtesy of SUZUKI OF AMERICA CORP.
Remove the bolt retaining the compressor clutch to the compressor.

Fig 3: Removing Compressor Retaining Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install GE-47849 to the compressor clutch.
Using GE-47849, remove the compressor clutch from the compressor.
Remove the compressor clutch shims from the compressor shaft.

Fig 4: Removing Snap Ring From Compressor Pulley
Courtesy of SUZUKI OF AMERICA CORP.
Remove the snap ring from the compressor pulley.
Using GE-47850 with J 25031-A, remove the compressor pulley from the compressor.

Fig 5: Removing Clutch Field Coil Connector Bracket Screw From Compressor
Courtesy of SUZUKI OF AMERICA CORP.
Remove the clutch field coil connector bracket screw from the compressor.

Fig 6: Removing Clutch Field Coil Screws From Compressor
Courtesy of SUZUKI OF AMERICA CORP.
Remove the clutch field coil screws from the compressor.

Fig 7: Identifying Clutch Field Coil From Compressor
Courtesy of SUZUKI OF AMERICA CORP.
Remove the clutch field coil from the compressor.